These wrenches are designed to fit Rearden muzzle devices:
- 13/16″ for Muzzle Device flats
- 1/4″ Thick to fit in the thinnest of places
They also include a 3/8″ drive cutout for use with an appropriate torque wrench.
They are made of 17-4PH Stainless and heat treated to H900.
To install your muzzle device, apply Rocksett and torque to approximately 15-25 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean.
This wrench is not recommended for untorquing muzzle devices or breaking Rocksett. Wrench is not designed to exceed 25 ft lbs. Improper use can lead to slipping off flats and damaging your threads. Too must torque can disfigure the wrench.
*Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned thoroughly and the muzzle device has been Rocksett to the barrel.*